PARK BRAKE LEVER
Always apply the service brakes before engaging or releasing the park brake. To
help prevent the vehicle from rolling, set the park brake when parking the
vehicle.
TIP
This feature will not operate properly if the park brake connector or switch
(under the hood) malfunctions or becomes disconnected, or if the switch has
moved. See your dealer or other qualified service person promptly if this
feature fails to operate properly. If the switch is disconnected, the park brake
light will be on and a signal will sound if the engine revs above a certain
threshold while the vehicle is not in park.
1. To set the park brake, apply the brakes. Pull the park brake lever towards
yourself as far as possible.
2. To release the park brake, apply the brakes. Turn the park brake lever
counterclockwise and push it in as far as possible.
SEAT
SEAT REMOVAL
To remove the driver’s seat, lift up on the rear of the seat and rotate the seat
base up and forward.
To put the passenger seat into the upright position, lift up on the front of the seat
and raise it to the upright position.
35
FEATURES AND CONTROLS
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
