62
MAINTENANCE
POLARIS Variable Transmission (PVT) System
PVT Drying
There may be some instances when water is accidently ingested into the PVT system. Use
the following instructions to dry it out before operating.
NOTICE: Do not attempt to start the engine if water is present in the air box.
1. Position the vehicle on a level surface.
2. Remove the drain plug. Allow the water to drain completely. Reinstall the drain plug.
3. Apply the brakes. Start the engine.
4. Engage the park brake. Shift the transmission to neutral.
5. Apply varying throttle for 10-15 seconds to expel the moisture and air-dry the belt and
clutches. Do not hold the throttle wide open for more than 10 seconds.
6. Allow the engine RPM to settle to idle speed. Apply the service brakes. Release the park
brake and shift the transmission to the lowest available range.
7. Test for belt slippage. If the belt slips, repeat the process.
8. Take the vehicle to your dealer for service as soon as possible.
Vehicle Immersion
NOTICE: If your vehicle becomes immersed, major engine damage can result if the machine is not
thoroughly inspected. Take the vehicle to your dealer before starting the engine.
If it's impossible to take your RANGER to a dealer before starting it, follow the steps outlined
below.
1. Move the vehicle to dry land or at the very least, to water below the floorboards.
2. Inspect the air box for water.
NOTICE: Do not attempt to start the engine if water is present in the air box. Engine damage will
result. Take the vehicle to your dealer before starting the engine.
3. If the air box is wet but has no visible water, dry the air box.
4. Thoroughly dry the air pre-cleaner located under the hood.
5. Take the vehicle to your dealer for service as soon as possible, whether you succeed in
starting it or not.
6. If water has been ingested into the PVT follow the procedure on page 62 for drying.
To Next Page
Loading...
Need help?
General
