4. Place a drain pan under the engine crankcase and remove the drain plug.
Allow the oil to drain completely.
5. Remove all cargo from the cargo box.
CAUTION
Always remove all cargo from the cargo box before lifting the box to access the
engine.
6. Pull up on the cargo box release lever to tilt the box.
7.
Using the Oil Filter Wrench, turn the oil filter
w
counter-clockwise to remove
it.
8. Using a clean dry cloth, clean the filter sealing surface on the engine
crankcase.
9. Lubricate the O-ring on the new oil filter with a film of fresh engine oil. Check
to make sure the O-ring is in good condition. Install it to specification.
TORQUE
Oil Filter
Turn by hand until filter O-ring contacts sealing surface, then turn an
additional 3/4 turn.
10. Replace the sealing washer on drain plug.
NOTICE
The sealing surface on the drain plug should be clean and free of burrs, nicks
or scratches.
11. Reinstall the engine crankcase drain plug. Torque drain plug to specification.
TORQUE
Crankcase Drain Plug
12 ft-lbs (16 Nm)
12. Remove oil fill cap. Fill engine with recommended engine oil.
13. Verify the transmission is still in PARK.
14. Start the engine and allow it to idle for 30 seconds.
15. Stop the engine and inspect for oil leaks. Wait at least 15 seconds before
removing the dipstick.
118
MAINTENANCE
To Next Page
Loading...
