BRAKE SYSTEM BREAK-IN
Apply only moderate braking force for the first 50 stops. Aggressive or overly
forceful braking when the brake system is new could damage brake pads and
rotors.
PVT BREAK-IN (CLUTCHES/BELT)
A proper break-in of the clutches and drive belt will ensure a longer life and
better performance. Break in the clutches and belt by operating at slower
speeds during the break-in period as recommended. Pull only light loads. Avoid
aggressive acceleration and high speed operation during the break-in period.
If a belt fails, always clean any debris from the PVT intake and outlet duct and
from the clutch and engine compartments when replacing the belt.
PRE-RIDE INSPECTION
WARNING
Failure to inspect and verify that the vehicle is in safe operating condition
before operating increases the risk of an accident. Always inspect the vehicle
before each use to make sure it's in safe operating condition.
ITEM REMARKS PAGE
Brake system/pedal travel Ensure proper operation page 137
Brake fluid Ensure proper level page 137
Front suspension Inspect, lubricate if necessary page 115
Rear suspension Inspect, lubricate if necessary page 115
Steering Ensure free operation -
Tires Inspect condition and pressure page 141
Wheels/fasteners Inspect, ensure fastener tightness page 141
Frame nuts, bolts, fasteners Inspect, ensure tightness -
Drive Belt Inspect, ensure installed correctly -
Fuel and oil Ensure proper levels page 115
Coolant level Ensure proper level page 124
Coolant hoses Inspect for leaks -
Throttle Ensure proper operation page 53
Indicator lights/switches Ensure proper operation
page 49
80
OPERATION
To Next Page
Loading...
Need help?
General
