40
OPERATION
Starting the Engine
1. Sit in the driver’s seat and fasten the seat belt.
2. Secure the cab nets.
3. Place the transmission in neutral. Set the parking brake.
4. Apply the brakes.
5. Do not press the throttle pedal while starting the engine.
6. Turn the ignition key past the ON/RUN position to START. Engage
the starter for a maximum of five seconds. Release the key when the
engine starts.
NOTICE: Operating the vehicle immediately after starting could cause engine
damage. Allow the engine to warm up for several minutes before
operating the vehicle.
7. If the engine does not start within five seconds, return the ignition
switch to the OFF position and wait five seconds. Repeat steps 6
and 7 until the engine starts.
8. Vary the engine RPM slightly with the throttle to aid in warm-up
until the engine idles smoothly.
9. Release the parking brake before driving.
To Next Page
Loading...
