SEAT BELT INSPECTION
Inspect all seat belts for proper operation before each use of the vehicle.
1. Push the latch plate into the buckle until it clicks. The latch plate must slide
smoothly into the buckle. A click indicates that it's securely latched.
2. Push the red release latch in the middle of the buckle to make sure it
releases freely.
3. Pull each seat belt completely out and inspect the full length for any damage,
including cuts, wear, fraying or stiffness. If any damage is found, or if the seat
belt does not operate properly, have the seat belt system checked and/or
replaced by an authorized dealer.
4. To clean dirt or debris from the seat belts, sponge the straps with mild soap
and water. Do not use bleach, dye or household detergents.
DOORS AND CAB NETS
Riding in this vehicle without using the cab nets or doors increases the risk of
serious injury or death in the event of an accident or rollover.
Cab nets must be used by both operator and passenger at all times. Make sure
all latches are secure before operating the vehicle.
Always inspect doors and cab nets for tightness, wear, and damage before each
use of the vehicle. Promptly replace worn or damaged doors, cab nets, or
latches with new components. Your Polaris dealer can assist.
FUEL CAP
WARNING
Never allow a child to refuel or handle gasoline.
The fuel tank filler cap
q
is located on the right-hand side of the vehicle near the
passenger seat.
When refueling, always use either
leaded or unleaded gasoline with a
minimum pump octane number of 87 R
+M/2 octane. Non-ethanol fuel is
recommended.
Do not use fuel with ethanol content
greater than 10 percent, such as E-85
fuel.
38
FEATURES AND CONTROLS
To Next Page
Loading...
Need help?
General
