FLUID CHANGE
1. Elevate the vehicle using appropriate jack stands. Make sure the elevated
vehicle is level.
2. Remove the fill plug.
3. Place a drain pan under the drain plug
w
.
4. Remove the drain plug. Allow the fluid to drain completely.
5. Clean and reinstall the drain plug with a new o-ring. Torque to specification.
TORQUE
19-35 ft-lbs (26-48 Nm)
6. Add the recommended fluid. Do not overfill. Maintain the fluid level at the
bottom edge of the fill hole.
FLUID CAPACITY
2.75 qts (2.6 liters)
7. Reinstall the fill plug with a new o-ring. Torque to specification.
TORQUE
19-35 ft-lbs (26-48 Nm)
8. Check for leaks. Dispose of used fluid properly.
106
MAINTENANCE
To Next Page
Loading...
Need help?
General
