3. Release the strap, it will self-tighten.
WARNING
Failure to wear the seat belt properly could result in serious injury or death.
Wear the shoulder belt on the inside shoulder only. Never wear the shoulder
belt under your arm or behind your body.
4. To release the seat belt, press the square red button
w
at the center of the
latch housing.
SEAT BELT INSPECTION
Inspect all seat belts for proper operation before each use of the vehicle.
1. Push the latch plate into the latch housing until it clicks. The latch plate must
slide smoothly into the housing. A click indicates that it’s securely latched.
2. Push the red release latch at the center of the latch housing to make sure it
releases freely.
3. Pull each seat belt completely out and inspect the full length for any damage,
including cuts, wear, fraying or stiffness. If any damage is found, or if the seat
belt does not operate properly, have the seat belt system checked and/or
replaced by your authorized dealer or another qualified person.
4. To clean dirt or debris from the seat belts, sponge the straps with mild soap
and water. Do not use bleach, dye or household detergents.
58
FEATURES AND CONTROLS
To Next Page
Loading...
Need help?
General
