OPERATING CRUISE CONTROL
The cruise control switches/buttons are located on the steering wheel. Make
sure you read this section and understand how to safely operate this feature
before using the cruise control.
WARNING
Improper operation of cruise control could cause loss of control and result in
serious injury or death. Follow all cruise operation procedures carefully. Never
use cruise control when roads are wet or slippery. Do not use cruise control
when driving in heavy or congested traffic.
NOTICE
Cruise control functions will not be available until the brake has been applied
firmly at least once after a restart of the vehicle.
CRUISE CONTROL TIPS
• Cruise control can be set in gears 3-5 (excluding vehicles with AutoDrive
Transmission).
• Vehicle speed must be above 30 MPH (48 km/h).
• Set speed will vary slightly in hilly terrain.
• The cruise control will not resume a pre-set speed if the resulting acceleration
or deceleration rate is too high or too low. For example, resuming a set speed
from 30 MPH (48 km/h) while in 5th gear may cause cruise to disengage.
• Cruise control may not engage if brake lights are not operating properly.
• Cruise control will be disabled if there is an active stability or traction control
event.
• Cruise control will be disabled if there are multiple wheel speed sensor faults
or a communication error with the electronic stability module.
88
OPERATION
To Next Page
Loading...
Need help?
General
