ENGINE
3.53
33. Apply Crankcase Sealant (PN 2871557)tothe
outside edges of the crankcase halves (See
arrows), where the crankcases mate. (See
photos below.) This helps to prevent coolant
leakage.
34. Install the gear/stator housing gasket onto he
crankcase.
35. Secure the gear/stator housing cover (O) to the
crankcase with the cover bolts. Apply Loctitet
242 (PN 2871949) to the bolts. Torque bolts to
8.5-9.5 ft.lbs. (12-13 Nm) in a criss--cross pattern.
Remove seal protectors from the shaft ends once
secure.
(PA--45401)
(PA--45658)
O
NOTE: Before assembly, clean the bolts and bolt
holes with Primer N (PN 2870585) to remove any
debris. This will ensure proper sealing when installing
bolts and new Loctitet.
Gear/Stator Housing Cover Bolt Torque:
8.5-9.5 ft. lbs. (12-13 Nm)
36. Install shaft seal with ceramic surface facing
inward.
37. Install water pump impeller (P). Secure the
impeller with the washer and a new nylok
nut
(Q)
. Torque the nut to 8.5-9.5 ft. lbs. (12-13 Nm).
Enfocus Software - Customer Support
To Next Page
Loading...
