FINAL DRIVE
7.6
bell, lift one edge of boot to let out excess air
Secure with clamp.
FRONT SHAFT
Joint Capacity
30 Grams
Boot Capacity
30 Grams
Front outboard joint capacity:
30g if boot is replaced only.
Another 30g (60g total) if joint is
cleaned.
FRONT HUB DISASSEMBLY
1. Remove outer snap ring.
2. From the back side, tap on the outer bearing race
with a drift punch in the reliefs as shown.
NOTE: Drive bearing out evenly by tapping on outer
race only. Once bearing is at bottom of casting,
support casting on outer edges so bearing can be
removed.
3. Inspect the bearing.
NOTE: Due to extremely close tolerances and
minimal wear, the bearings must be inspected
visually, and by feel. While rotating bearings by hand,
inspect for rough spots, discoloration, or corrosion.
The bearings should turn smoothly and quietly, with
no detectable up and down movement and minimal
movement sideways between inner and outer race.
4. Inspect bearing housing for scratches, wear or
damage. Replace housing if damaged.
FRONT HUB ASSEMBLY
1. Support bottom of hubstrut housing.
2. Start bearing in housing.
3. Press bearing into place until outer race bottoms
on housing.
CAUTION:
When using an arbor press be sure to press only on
the outer race, as bearing damage may occur.
4. Install snap ring into groove.
FRONT PROP SHAFT
REMOV
AL
1. Using Roll Pin Removal Tool (PN 2872608),
remove the roll pin from prop shaft at rear of
housing. Slide prop shaft back and away from
front housing. Pull sharply forward to remove
from transmission shaft.
Enfocus Software - Customer Support
To Next Page
Loading...
