FINAL DRIVE
7.12
12. Remove the other output hub from the main
gearcase.
13. Remove the O--ring and seal from the output
cover.
14. Remove the input cover, bearing, and the pinion
gear. Inspect the pinion gear for chipped, broken,
or missing teeth. Inspect the output shaft
bushing. Replace as needed. Clean the inside
surfaces of both gearcase halves.
FRONT GEARCASE
REASSEMBL
Y/INSPECTION
1. Replace all O--rings, seals, and worn
components.
2. Press the pinion shaft seal into the pinion cover,
until the seal is flush with the sealing surface.
3. Inspect bearings on output and pinion shafts. To
replace, press new bearing on to shaft.
NOTE: Due to extremely close tolerances and
minimal wear, the bearings must be inspected
visually, and by feel. While rotating bearings by hand,
inspect for rough spots, discoloration, or corrosion.
The bearings should turn smoothly and quietly, with
no detectable up and down movement and minimal
movement side to side.
4. Install pinion shaft, bearing, and input cover with
new o-ring and torque bolts to 14 ft. lbs (19 Nm).
Cover Bolts Torque
14 ft. lbs. (19 Nm)
5. Install the output hub into the gearcase housing.
The output hub should spin freely.
Enfocus Software - Customer Support
To Next Page
Loading...
