100
MAINTENANCE AND LUBRICATION
Cleaning and Storage
Storage Tips
See page 106 for the part numbers of Polaris products.
CAUTION
Starting the engine during the storage period will disturb the
protective film created by fogging and damage could occur . Never
start the engine during the storage period.
Exterior
Make necessary repairs and then clean the ATV thoroughly with mild
soap and warm water to remove all dirt and grime. Don’t use harsh
detergents or high pressure washers. Some detergents deteri orate rubber
parts. Use dish soap type cleaners only. High pressure washers may
force water past seals.
Fuel Stabilizer
Polaris Carbon Clean is a fuel stabilizer and fuel system dryer. It
cleans the fuel system, the combustion chamber and the exhaust ports.
It also prevents bacterial growth and promotes better starting after the
storage period.
1. Fill the fuel tank with fuel and add Polaris Carbon Clean or Fuel
Stabilizer . Follow the instructions on the container for the
recommended amounts.
2. Start the engine and allow it to run for 15-20 minutes so the stabilizer
can disperse through the fuel in the tank and carburetor.
3. Stop the engine, turn the fuel valve of f, and drain the carburetor bowl.
Air Filt er / Air Box
Inspe ct and clea n or replac e the pre-clea ner and air filter. Clea n the air
box and drain the sediment tube.
Recoil Hous ing
Remove the recoil housing drain plug and drain any moisture.
Fluid Levels
Inspect the following fluid levels and change if necessary: engine oil;
transmission oil; brake fluid (change every two years or as needed if
fluid looks dark or contaminated).
To Next Page
Loading...
Need help?
General
