93
MAINTENANCE AND LUBRICATION
Recoil Housing
To prevent possible engine damage,
always drain the recoil housing (1)
afteroperatingtheATVinverywet
conditions. This should also be
done before storing the ATV.
Water will enter the recoil housing
if the starter handle is disengaged
from the rope guide when under
water. The recoil handle must be
behind the heat shield for it to seal
properly.
The drain screw is located at the bottom of t he recoil housing. Use a
wrench to remove the screw. Be sure to reinstall the screw after
draining the housing.
1
To Next Page
Loading...
