66
MAINTENANCE AND LUBRICATION
Periodic Maintenance Chart
Item Maintenance Interval
(whichever comes first)
Remarks
Hours Ca le ndar Miles
(Km)
Carburetor float
bowl
50 H 6M 500 (800) Drain bowl periodically and
prior to storage
J
E
Throttle Cable/
ETC Switch
50 H 6M 500 (800) Inspect; adjust; lubricate;
replace if necessary
J
E
Choke cable 50 H 6M 500 (800) Inspect; adjust; lubricate;
replace if necessary
E
Carburetor air
intake ducts/
flange
50 H 6M 500 (800) Inspect ducts for proper
sealing/air leaks
Drive belt 50 H 6M 500 (800) Inspect; adjust; replace as
needed
"
E
Engine oil change 100 H 6M 1000 (1600) Perform a break-in oil
change at one month
"
E
Oil filter change 100 H 6M 1000 (1600) Replace with oil change
J
E
Valve clearance 100 H 12 M 1000 (1600) Inspect; adjust
J
E
Fuel system 100 H 12 M 1000 (1600) Check for leaks at tank cap,
lines, fuel valve, filter , pump,
carburetor; replace lines
every two years
J
E
Fuel filter 100 H 12 M 1000 (1600) Replace yearly
"
Engine mounts 100 H 12 M 1000 (1600) Inspect
Exhaust muffler/
pipe
100 H 12 M 1000 (1600) Inspect
J
E
Spark plug 100 H 12 M 1000 (1600) Inspect; replace as needed
J
E
Ignition T iming 100 H 12 M 1000 (1600) Inspect
"
Wiring 100 H 12 M 1000 (1600) Inspect for wear, routing,
security; apply dielectric
grease to connectors
subjected to water, mud, etc.
J
Clutches (drive
and driven)
100 H 12 M 1000 (1600) Inspect; clean; replace worn
parts
J
Front wheel
bearings
100 H 12 M 1000 (1600) Inspect; replace as needed
To Next Page
Loading...
