SETUP
CHANGE
BACK
SYSTEM
CHANNEL
FINE TUNE
SEARCH
PROGRAM NO
STORE
AUTOPROGRAM
BG
S06
0
P13
6.3.6.6-Common Interface Module
In this menu, you can make the CI Module
settings that you can attach to your
television.
6.3.6.7-System Menu
You can display your television’s hardware
and software data under this menu.
6.4-Performing Analog
Tunings
You can either tune the Analog channels
automatically or manually and store them in
your television.
6.4.1-Automatic tuning of channels
and storing in the memory
Note: If your television does not receive any
antenna broadcast for a period of 5 minutes,
it automatically switches to the stand-by
position. The countdown OSD is displayed
on the screen during the last 1 minute
(applicable for Analog mode only)
You can tune the programs automatically
with the Autoprogram function of your
television and then sort the channels as you
desire by means of the Program Table. Press
AV button on your remote control, select
ANALOG TV tab from the SOURCE menu
by using Up/Down movement buttons
and confirm by pressing the OK button.
Your TV will switch to Analog mode. Press
the MENU button on your remote control.
Select SETUP tab with Down movement
button and confirm with OK button. Setup
menu is displayed.
select AUTOPROGRAM tab by using the
Up/Down movement buttons and press
OK button; Country Selection menu will be
displayed.
In the Country Selection menu, select the
country, whose broadcast you would like to
watch in priority, by pressing the right/left
movement buttons and start autoprogramming
by pressing the OK button. The channels will
be automatically searched and those found
will be stored in memory starting from the
program selected in the Setup menu. At the
same moment, the Autoprogram menu will be
displayed and a marker indicating the progress
of the autoprogramming will appear as shown
below.
Select PROGRAM NO tab by pressing
the Up/Down movement buttons in Setup
menu, enter the channel number to be
searched and stored automatically, then
To stop the process at any given time,
please press the MENU button. The
Program Table, which will allow you to sort
the channels as you wish, will be displayed
after the automatic search is complete.
6.4.2-Manual tuning of channels and
storing in the memory
6.4.2.1-Ifyoualreadyknowthe
channel number
Press the MENU button. Move to the
SETUP menu by pressing the Down
movement button in the Main Menu and
confirm your selection with the OK button.
Setup menu will be displayed.
To Next Page
Loading...
Need help?
General