Setting up 11
2 Insert a small screwdriver into the slot of the SCSI ID
selector on the camera and rotate the selector until the arrow
points to the desired SCSI ID.
Scsiwit.ai
Note: Do not use 7 or 0, which are customarily reserved for
the computer and for PowerMac/PowerPC hard drives. If
possible, you should also avoid SCSI ID 3, which is often
used for internal CD-ROM drives.
Attaching the camera to your microscope
Note: Attaching the DMC camera to your microscope
requires a .63 or 1:1 c-mount adapter (not provided)
compatible with your microscope. Do not use a .5 c-mount
adapter, because it will produce image vignetting (dark
corners). Refer to the microscopes instruction manual or
contact the microscope manufacturer for more information
about c-mounts.
Caution: Before attaching a c-mount adapter or lens to the
camera, verify that the threaded end of the adapter (a) does
not exceed 0.195 inches (5mm). Longer c-mount adapters
may damage the camera. (The drawing below is actual size to
help you check the thread length of your c-mount adapter.)
=
cmadap2.cdr
To Next Page
Loading...
