The helmet mount can be used on a standard bicycle helmet by securing with the
included helmet mount straps and adhesive pads on the underside of the mount.
Optional: Remove the protective seal on the adhesive strip and place on your bike
helmet so that it sticks in place.
Using the Helmet Mount
1. Take one of the large straps and
thread it down through the slot on
the helmet mount base.
2. Take the end of that strap and
thread it through one of the ports
on a bicycle helmet and then out
through another port.
3. Slide the end of the strap through the
strap’s clip and adjust until the strap
feels properly secure and in place, then
press the clip until it clicks into place.
Using the adhesive strips, fasten the
loose ends of the large strap to other
ports on the bicycle helmet.
4. Repeat steps 1-3 with the other
strap.
5. Slide the fastener into the base and
attached the camera to the top of
the helmet mount.
To Next Page
Loading...
Need help?
General
