There are several Flash options available on your camera. The selected option appears on the
Photo Capture Mode LCD screen.
To change the Flash mode:
1. Short press MENU button while in Photo Capture Mode.
2. Press the DOWN or UP button until the ‘Flash’ option is selected.
3. Press the OK/SHUTTER button to enter the Flash options
4. Press the DOWN or UP button to select and highlight the desired Flash option.
5. Press the OK/SHUTTER button to select and save the desired Flash option and to then
return to the Photo Capture Menu screen.
Important:
When using Flash, stand between 8 to 10 feet away from the scene you would like to capture.
The MACRO mode must be turned OFF when you want to use the Flash.
To change the Macro setting: Select ‘Macro’ from the Photo Capture Mode Menu, then select
the ‘OFF’ Macro setting option.
Use this when you do not want to activate Flash.
The flash is enabled for each photo.
Note: If you use this option in a well-lit environment, your photo
may be appear too bright/light (overexposed).
When you want the camera to determine if Flash is needed, select
Auto Flash.
The flash will automatically turn on according to the lighting
conditions.
When the LED light stops blinking, the Flash is ready for use.
Eliminates the red-eye effect in a photo caused by flash.
To Next Page
Loading...
Need help?
General
