46
Specifications
Before consulting service personnel, check the following chart for a possible
cause of problem and for a possible solution.
Audio noise
Move any infrared equipment away from the TV.
TV will not turn on
Make sure the power cord is plugged in, then press the button on the remote.
Make sure the AC switch on the rear of the TV is turned on.
The batteries in the remote control may be exhausted. Replace the batteries.
No picture, no sound
Check the interface cable between TV and antenna/cable TV.
Press the button on the remote.
Press the INPUT button on the remote repeatedly to select the connected video
sources.
Picture OK, poor sound
Sound may be muted. Press the button on the remote.
Press the VOL+ button to increase the volume.
Check Audio Settings (see section entitled “Customizing the AUDIO Settings”).
TROUBLESHOOTING
Poor picture, sound OK
Check the interface cable between TV and antenna/cable TV.
Try another channel, the station may have broadcast diffi culties.
Adjust the Brightness/Contrast options in the VIDEO Menu.
To Next Page
Loading...
