SETUP
BG
S06
0
P13
SELECT
BACK
SYSTEM
CHANNEL
FINE TUNE
SEARCH
PROGRAM NO
STORE
AUTOPROGRAM
6.3-Manually searching and
storing the channels
6.3.1-If you already know the Channel
number:
Press the MENU button. Move to the
SETUP menu by pressing the P-
movement button in Main Menu and
confirm your selection with OK button.
The Setup menu is displayed. Select
the system in which you would like to
make the search from the SYSTEM
tab by pressing the –VOL, VOL+
buttons.
Move into CHANNEL by pressing the
P- movement button. Press OK on
your remote control and select “S” for
cable channels and “C” for channels
received via the antenna. Move onto
the PROGRAM NO tab and enter the
channel number in which you would
like to have the channel stored. If the
broadcast viewed on the screen is of
your desired quality, first move onto
the STORE tab with the P- movement button
to store in the memory the selection you have
made and store the channel by pressing the -
VOL or VOL+ movement buttons. The prompt
STORED will be displayed briefly. The channel
will be stored according to the program
number of your choice. You can tune and
store in memory other channels the same way.
In the event that you wish to exit the channel
settings menu for any reason, simply press the
MENU button.
press OK button and Country
Selection menu is displayed. In the
Country Selection menu, select
the country, whose broadcast you
would like to watch in priority, by
pressing the P+/P- or -VOL/VOL+
movement buttons and start
autoprogramming by pressing the
OK button. The channels will be
automatically searched and those
found will be stored in memory
starting from the program selected
in the setup menu.
At the same moment, the Autoprogram
menu will be displayed and a marker
indicating the progress of the
autoprogramming will appear as shown
below.
To stop the process at any given time,
please press the MENU button. The
Program Table, which will allow you to sort
the channels as you wish, will be displayed
after the auto-search is complete.
Note: During autoprogramming it’s not
possible to turn to standby mode. First of all
you have to exit autoprogramming.
6.3.2-If you do not know the channel
number
Press the MENU button. Move to
the SETUP menu by pressing the
P- movement button in Main Menu
and confirm your selection with
To Next Page
Loading...
Need help?
General