PROGRAM TABLE
00
Channel 01
Channel 02
03
04
05
06
07
08
09
10
11
12
13
14
SKIP
MOVE
NAME
DELETE
SELECT
BACK
OK button. The Setup menu is
displayed. Select the system in
which you would like to make the
search from the System tab. Move
into CHANNEL by pressing the
P- movement button. Press OK
on your remote control and select
“S” for cable channels and “C” for
channels received via the antenna.
Select SEARCH tab using the
P+/P- movement buttons, and scan the
channels in ascending order with VOL+
movement button and in descending order
with -VOL movement button. If the channel
that is found is of your liking, select the
STORE tab. Then store it in the memory
pressing the VOL+ or -VOL movement
buttons. Repeat the same procedure for
other channels by selecting the program
number of your choice from the PROGRAM
NO tab. If the channel you found is not of
the desired quality and requires Fine Tuning
or if you would like to rename the channel,
refer to the relevant sections.
6.4-Fine Tuning
If the channel you found is not of
the desired quality, then select the
FINE TUNE tab by pressing the
P- movement button in the Setup
menu.Usingthe–VOL/VOL+
movement buttons on your remote
control, adjust the broadcast
displayed on the screen to your desired
quality.Undernormalcircumstances,
you will not require to use the Fine Tune
function. The AFC values of your television
will automatically adjust and lock themselves
to the channel. However, you might need
it in case the television transmitters do not
operate according to the standards. To store
in the memory, the settings you have made,
select the STORE tab and press the VOL+
or -VOL movement button.
6.5-Program Table
Press the MENU button. Move to the
PROGRAM TABLE tab by pressing the
P- movement button in Main Menu and
confirm your selection with the OK button.
You can also enter the program table directly
by pressing the PT button on your remote
control.
6.5.1-Switching the locations of the
stored channels:
Select the program you would like
to relocate by pressing the P+/P- or
–VOL/VOL+ movement buttons.
“Press the “GREEN” colored button.
Channel name will become green.
Move to the other program you
would like to relocate by pressing the
P+/P- or –VOL/VOL+ movement
buttons. Finish the relocation process
by pressing the “RED” colored
confirmation button. The channel in
the first program number you selected
has been moved to your second
selected program number and the channels
between both program numbers have been
shifted to the initially selected program number.
After setting is complete, press the MENU
button to exit the menu.
6.5.2-Deleting a stored channel:
Select the program you would like
to delete from the program table by
pressing the P+/P- or –VOL/VOL+
movement buttons. “Press the
“BLUE” colored button. You can
perform the deletion process by
pressing the “RED” confirmation button or
abort the process by pressing the “GREEN”
button. “Once you pres the “RED” button, the
selected program is deleted and the following
channels are transferred to previous program
number. After setting is complete, press the
MENU button to exit the menu.
To Next Page
Loading...
Need help?
General