Polaroid OneStep+ - Getting Started with Your OneStep+; Box Contents and Initial Setup; Loading Film and Ejecting Photos

User Manual
14
User Manual
15
How to use
the OneStep+
Charge the camera
Important The OneStep+ will
not be fully charged upon
purchase — it should be fully
chargedbeforefirstuse.To
charge the camera, plug
the USB charging cable into
the Micro-USB slot on the
camera’s back panel, and
the other end of the cable
into a charger, such as a
smartphone adapter or your
computer’s USB slot. The
redashchargeLEDwillturn
off when the battery is fully
charged.
A full charge usually takes
about 2 hours through a
wall socket with a smart-
phone adapter, or up to 4
hours through a computer’s
USB slot. A fully-charged
OneStep+ camera will have
enough power to shoot 15-20
packsoffilm,dependingon
usage. Remember to turn
your camera off after every
use to conserve battery life.
Box contents
01 OneStep+ Camera
02 USB Charging Cable
03 User Manual
04 Camera Neck Strap
1. Turn the
camera on/off
To turn the camera on, slide
the power switch into the ON
position(down).Theash
charging LED on the back pan-
el will start blinking to charge
theash,andtheremaining
filmcounteronthetopofthe
camera will light up to indicate
that the camera is switched
on, and show the amount of re-
mainingfilmifafilmcassetteis
loaded. To turn the camera off
again, return the power switch
to the OFF position.
2. Load the lm
Slidethefilmdoorlatchtothe
righttoopenthefilmdoor.
Pushthefilmcassetteallthe
wayin,withthefilm’sdarkslide
facing up.
Note Please check
individualfilmpackaging
for development time,
handling and storage
details.
3. Close lm door
Whenyouclosethefilmdoor,
the darkslide will eject from
the camera automatically,
underneaththefilmshield.
Theplasticfilmshieldis
designed to protect images
from light as they develop — it
should not be removed. Take
the darkslide out from under
thefilmshieldandletthefilm
shield roll back up. If the dark-
slide has not ejected, remove
thefilmpackandre-insertit,
making sure it is pushed all
the way to the back of the
camera.
4. Set the Flash
& Lighten/Darken
Flash Thecameraashwill
trigger by default when you
shoot with the OneStep+. To
shootwithouttheash,press
andholdtheashoverridebut-
ton on the back panel as you
press the shutter button.
Warning Shooting without
ashwillreducecamera
performance and picture
qualityinmostlighting
situations except brightly-
lit, sunny environments.
We recommend always
shootingwithash.