• Setting Flash Mode
1. Turn on the camera.
2. Set the camera to Still Image mode.
3. Press the Flash button to cycle through the ash settings and select
the one you need.
When you press the Flash button, the Flash Charge LED will blink, which
indicates the ash is charging. The icon (according to the ash setting
you selected) will appear on the LCD screen. You can now take pictures
using the Flash mode you selected. The ash will recharge after each
ashed picture.
The ash range is approximately 3 feet to 8 feet (0.9 to 2.4 meters).
The camera has four ash modes (default setting is Auto Flash). Use
the ash when you take pictures at night, indoors, or outdoors in heavy
shadows.
Flash Off Mode. The ash does not re. Use this setting for
outdoor pictures or where ash is prohibited or may be distracting.
Also use when shooting towards a reective surface, such as a
window or a mirror. If the brightness of the environment is not
enough when using this setting, your pictures will be too dark.
Auto Flash Mode. The ash res automatically as needed. Use this
setting to take most pictures.
Red-eye Reduction Mode. Use this setting to avoid red glare in
your subject’s eyes. The camera res a brief, preash ash before
the regular ash.
Forced On Mode. The ash res for every picture. Use this setting
in high-contrast situations to provide ll-light or use it indoors
with low light.
NOTE:
• Flash modes are not available in Video mode.
• Never touch or block the ash with your ngers. Doing so can soil these
components and interfere with the correct ash operation.
To Next Page
Loading...
Need help?
General
