EN-26
Setting the Self-timer
This setting allows images to be captured with the self-timer.
1. Slide the mode switch to [ ] or [ ].
2. Toggle the button to select the setting.
For the [ ] mode.
OFF [ 10s] 10 sec. [ 2s ] 2 sec.
[ 10+2s ] 10+2 sec.
For the [ ] mode.
OFF [ 10s ] 10 sec. [ 2s ] 2 sec.
3. Compose the image, press the shutter button down halfway, when you are
ready to take your picture press it down fully.
The self-timer LED flashes and the image is captured after the preset time has
elapsed.
The countdown is displayed on the LCD monitor.
To cancel the self-timer during operation, press the shutter button halfway.
The table below will help you choose the appropriate self-timer mode:
Self-timer mode Description
[ 10s] 10 sec.
The image is captured about 10 seconds after the shutter
button is pressed.
[ 2s] 2 sec.
The image is captured about 2 seconds after the shutter
button is pressed.
[ 10+2s]10+2 sec.
One image is captured about 10 seconds after the shutter
button is pressed, and another image iscaptured again
after 2 seconds. This is convenient when capturing group
images in succession.
To Next Page
Loading...
Need help?
General
