www
.PolkAudio.com
/ 800.377.7655 (USA & Canada) / 410.358.3600 (W
orldwide)
1
CSW100
Custom Install Subwoofer
The CSW100 subwoofer is a bandpass design with slot-load venting and has a 10 inch long-throw driver. The
CSW100 fits standard joist spacing and is designed specifically for floor and ceiling installation, or custom enclos-
ures that are at least nine inches (9”) deep. All sound comes from an opening approximately 13 inches long by 3
inches wide. There is an access panel on the back of the subwoofer should the driver have to be removed for service.
Hardware (included)
• 1 Subwoofer
• 4 Mounting Brackets
• 16 - 3/4" Particle Board Panhead Screws
• 16 Washers
• 3 Isolation Pads
• 1 Registration Card
• 1 Owner’s Manual (also available online)
• Plastic molded grille
• 6 Rubber Buttons (to cover grille screw holes)
Protective Cover
A 1/2" thick protective cover of MDF covers the
CSW100 grille opening. This protective cover
(3 - 1/4" x 13") is also the template you will use to
cut the grille opening. Affixed to the MDF cover
is the following label:
If you choose to use another grille, use one
that doesn’t resonate and caulk it.
Isolation
Pads
Mounting
Brackets
and Screws
Wood Joist
Wood Joist
Top View
of CSW100
Subwoofer
in floor
Available Finishes: Black
THIS DOCUMENT APPLIES TO CSW100, CSW200, AND SWA500 PRODUCTS
All the bass
comes out
of here!
To Next Page
Need help?
General
