Polk Mono PRC200BC - User Manual

PRC200BC Marine Remote Control
Installation and Operation Guide
Trim Ring
Figure A
- Installation
#6 Pan Head Screw
.
Length
Introduction
Thank you for choosing a Polk product. The PRC200BC marine remote control allows convenient operation of
compatible Polk marine source units. Operation includes power on/off, volume adjustment, mode selection,
and basic functions of available sources such as AM/FM tuner, Weather Band, Bluetooth, USB, iPod/iPhone,
and SiriusXM satellite radio.
Up to three Polk marine remote controls (PRC100BC and/or PRC200BC) can be connected to a compatible
Polk marine source unit by using a remote control Y-cable (Part #: PRCYC1, sold separately). One Y-cable is
required for each additional remote control (e.g.: One Y-cable for two remote controls total, two Y-cables for
three remote controls total.)
Installation
1. Choose a smooth, flat, sturdy mounting location
that has been verified safe. Also verify there is
enough room to route the connection cable to
the source unit.
Important: Do not choose a mounting location
where remote control can become submerged.
2. Carefully cut a 1.63 diameter hole in the chosen
mounting surface. A mounting template is
supplied on the last page.
3. Route the supplied 18 extension cable from
remote control to source unit making sure the
correct sex of plugs are in the correct direction.
Connect the extension cable to source unit and remote control.
If a longer cable length is needed or additional remote controls are added, up to two additional 18
extension cables (Part #: PRCEC18, sold separately) can be connected for a total of 54 .
Important: Ensure that the route between source unit and remote control does not have any sharp,
abrasive edges, excessively tight bends or areas that can pinch the extension cable as this can negatively
affect performance and/or cause damage to connected devices.
4. Insert the remote control into the hole from the front of the mounting surface, align face to desired position
and secure to the mounting surface using #6 stainless steel pan head screws with minimum length of 3/4
(not included) as detailed in Figure A.

Summary

Introduction to Polk PRC200 BC Marine Remote Control

Installation Guide for PRC200 BC Remote Control

Selecting a Suitable Mounting Location

Choose a smooth, flat, sturdy location safe from submersion and with adequate space for cable routing.

Preparing the Mounting Surface

Cut a precise 1.63-inch diameter hole in the chosen mounting surface as per the template.

Connecting and Routing Extension Cables

Route the 18' extension cable, ensuring correct plug orientation and protection from damage.

Securing the Remote Control Unit

Insert the remote control from the front, align it, and secure with #6 stainless steel screws.

Operation of the PRC200 BC Remote Control

Main Buttons Functionality

Details the operation of Power, Volume Up, and Volume Down buttons across various modes.

Soft Buttons Functionality Overview

Explains the general usage of the four soft buttons (Key 1 to Key 4) for interactive control.

Additional Main Control Buttons

Describes the operation of Play/Pause, Enter Menu, and Mode selection buttons.

Soft Button Functions for Radio and USB;iPod

Details specific soft button operations for Radio tuning, presets, and USB/iPod navigation.

Soft Button Functions for Bluetooth, SiriusXM, and Weather Band

Details soft button operations for Bluetooth, SiriusXM, and Weather Band modes.

Polk Mono PRC200BC Specifications

General

Preamp Outputs	Yes
Auxiliary Input	Yes
Impedance	4 Ohms
UV Resistant	Yes
Waterproof	Yes
Peak Power Output	200 Watts