Polocool PC-53AP/C - Page 9

ATTENTION
• Theexhausthoseshouldbenotlongerthan1.5metres.
• Neverbendtheexhausthoseexcessivelywhentheapplianceisworking.
• Elevatetheunitifpossibletokeeptheexhausthosestraight.
• Alwayskeeptheexhausthoseatitsshortestlengthandasstraightaspossiblewhentheapplianceisworking.
Thiswillensuremaximumcoolingoutput.
• Nevermovetheappliancebypullingtheairexhausthoseattachedtothebackoftheappliance.
• Donotmovetheairconditionerwhenitisoperating.
Correct exhaust hose mounting shown below. If mounting in the wall, the height of the hole should be 17cm~130cm.
(Fig. 6)
If the air exhaust hose needs to be bent, the correct method is shown below. (Fig. 7)
Incorrect or excessive bending of the exhaust hose will cause loss of cooling and possible malfunction. (Fig. 8)
7
Fig. 8
Fig. 7
Fig. 6
NOBOCOOL NC-49DP/C
ATTENTION
• The exhaust hose should be not longer than 1.5metres.
• Never bend the exhaust hose excessively when the appliance is working.
• Elevate the unit if possible to keep the exhaust hose straight.
.gnikrow si ecnailppa eht nehw elbissop sa thgiarts sa dna htgnel tsetrohs sti ta esoh tsuahxe eht peek syawlA •
This will ensure maximum cooling output.
• Never move the appliance by pulling the air exhaust hose attached to the back of the appliance.
• Do not move the air conditioner when it is operating.
17cm
8