Poly Studio V72 - Page 11

Use the LED on the right side of the system to help you understand the system's behaviors.
You can change the administrator username and password to access the system web interface and
administrator sections of the local interface.
The default username is admin
and the default password is the last six characters of the system’s
serial number.
Procedure
1 In the system web interface, go to Security > Local Accounts.
2 Enter the new administrator username in the Admin ID field.
3 Select Change Password.
4 Enter the current password and then the new password.
Entering an incorrect current password too many times causes the system to automatically log
out and close the session.
5 Select Save.
LED Status Indicators for the Studio V72 System
Use the LED on the right side of the system to help you understand the system's behaviors.
Table 1. Basic Studio V72 LED Indicators and Status
Indicator Status
Off System powered off
Solid white System is idle and standing by
Pulsing white Boot initiation in progress
Pulsing amber Firmware update or factor restore in progress
Blinking blue and white Bluetooth pairing with a remote control
Solid blue for 3 seconds Bluetooth paired with a remote control
Page 11