Poly Studio V72 - Navigating the System; Change Administrator Credentials

•
Don’t restart or power off the system during maintenance activities (for example, while a software
•
update is in progress).
•
If a system restart is necessary, use the system web interface, RestAPI, Telnet, or SSH. If
•
possible, avoid using the power cable to restart the system.
Navigating the System
You can navigate the system using the system web interface.
Access the System W
eb Interface
Access the system web interface to perform administrative tasks.
The system web interface enables you to do the following actions:
•
Finish setting up your system.
•
•
Remotely configure and manage your system. Unlike the local interface, you can configure every
•
setting through the system web interface. Local interface is intended only for the initial setup.
Procedure
1 Open a web browser and enter the system IP address.
To view the system IP address, connect a monitor to an HDMI output port of your system. The
system IP address displays on the monitor
.
2 Enter the username (the default is admin).
3 Enter the password (the default is the last six characters of your system’s serial number).
The password is case sensitive.
Locate the system IP address using a monitor
Connect your Poly Studio V72 to a monitor and the IP address for Ethernet displays by default.
Procedure
• Connect a monitor to an HDMI output port of your Poly Studio V72 using the supplied HDMI
cable.
The Poly Studio V72 IP address for the Ethernet displays on the monitor.
Change Administrator Credentials
• LED Status Indicators for the Studio V72 System
Page 10