Connect all cables before powering on the system.
You can use your Studio V72
as an external video device on your computer or connect it to a
conferencing system that supports USB cameras.
•
Setting Up the System
See the setup sheets applicable to your system and its peripheral devices, including cameras,
monitors, microphones, and controllers.
•
Powering the System On and Off
The system powers on when you plug it in to a power source.
Setting Up the System
See the setup sheets applicable to your system and its peripheral devices, including cameras, monitors,
microphones, and controllers.
• Set Up Your Studio V72
You can connect your Studio V72
to your computer only using the supplied USB cable. You can
also connect Studio V72 to your network and to an external monitor.
Set Up Your Studio V72
Y
ou can connect your Studio V72
to your computer only using the supplied USB cable. You can also
connect Studio V72 to your network and to an external monitor.
Note
Before powering on your system, connect the system to your network and connect an
optional monitor.
Procedure
1 Connect the supplied USB cable from the USB-C port on the Studio V72 to your computer.
2 Optional: To view your system IP address, connect a monitor to an HDMI output port of your Poly
Studio V72 using the supplied HDMI cable.
3 Optional: Connect the system Ethernet port to your network using the supplied Ethernet cable.
4 Plug the system in to a power source using the supplied power supply cable.
The system powers on when you plug it in to a power source. If you have a monitor connected to
the system, the system IP address displays on the monitor.
Powering the System On and Off
The system powers on when you plug it in to a power source.
Poly recommends the following when powering off or restarting your system:
Page 9
To Next Page
Loading...