Polycom Group 700
Quick Guide
Showing Content
Some peripheral devices (DVD, VHS, computer, document camera) are physically connected to the Polycom
system as Content devices. This means that you can display the Content to your audience, in addition to a
Camera source.
Besides physically connected Content devices, you may also use the People+Content IP software installed on
the PC to display the PC as Content.
Content shown is from one site at a time; another site sharing content overrides any content being shared.
When you are showing content, a message appears on your main monitor. Whether you also see the content
on your monitor or projector depends on how your system was configured.
Showing Content from a Source Physically Connected to a System
To start showing content:
Using your remote control, select and then select your content source from the
list.
While in a call, you can select > Select on your remote to turn on and off the last
used content source.
To stop showing content:
Using your remote control, select > Hide and the name of your content source,
such as Hide Laptop.
Showing Content with People+Content IP
The People+Content IP application allows you to send content from a computer that is not connected
directly to the Polycom system.
To start showing content:
1. On your computer, start the Polycom People+Content IP application.
2. In People+Content IP, click .
To stop showing content:
1. If the People+Content IP toolbar is minimized, maximize it by clicking the icon in the
task bar.
2. Click in People+Content IP.
To Previous Page
Loading...
