Polygroup Funsicle Oasis Pool - Page 2

5. Connect the last horizontal beam with the Easy Link T-Fitting to complete the top frame.
6. Carefully slide the Vertical Legs up through
the liner’s belt that runs around the middle of
the pool, and then lock each one into the
hole of the T-Fitting.
7. Continue working around the perimeter until
the entire liner is securely connected to
the frame.
8. To make sure the poles are perpendicular to
the ground (and not leaning), pull the vertical
legs towards you. This will make the
walls straighter.
Funsicle Customer Service
Website: funsicle.com/support
Phone: 888-670-4FUN (888-670-4386)
Email: HelloFun@Funsicle.com
STEP THREE: Add 1 inch of water to the pool and then install filtration system.
1. After ensuring that the drain fitting is plugged securely and the cap is in place, fill the pool
with about an inch of water. Then stop filling, and smooth out all wrinkles in the liner.
3. Continue adding water to your pool and refer to the “Funsicle Oasis Pool User Guide”
for information and best practices for using, maintaining, draining, storing and/or
winterizing your pool.
2. Install the filtration system as per the enclosed “Funsicle Skimmerplus Filter Pump User Guide.”