Polyprint TEXJET - Start-Up Problems and Solutions; Plate Movement Stops with Red Limit Light; Pause Button Displayed; Service Required Error Message

POLYPRINT SA – TEXJET OPERATION MANUAL V6.4 EN
- 50 -
START UP PROBLEMS
Problem: The plate moves and stops. The red limit light is on.
Causes and Solutions:
The plate height has exceeded its maximum.
Press the down button until the red light switches off.
Problem: Press pause button is on the display
Causes and Solutions:
The printer is still starting up.
Press the pause button or wait. The printer continues the start up and goes on ready. This is a normal
function.
Problem:
After the printers start up you get the error message service required
(serv req)
Causes and Solutions:
Tray movement problem detected.
Please check for any object blocking the tray movement
The printer did a fatal operation.
Note down the exact message. Switch off the printer and start is again. If this message appears again
at the start up contact your dealer.
Problem: You switch on the printers but the Epson panel is not switching on
Causes and Solutions:
The plate stopped to move because its height has exceeded its maximum.
Press the down button until the red light switches off.
When switching on the printer, on the plate panel, the power led is Flashing.
Switch off the printer. Remove the power cable for 1min and pull it back again. If this happens again
contact your dealer.