4
Table of Contents
Section 1 - General Information
1.1 Warranty
1.2 Unpacking
Section 2 – Overview
2.1 Contents
2.2 Description
2.3 Chiller Specifications and Pump Performance
Section 3 – Installation and Startup
3.1 Site Requirements
3.2 Electrical Power
3.3 Optional Signal Inputs/Outputs
3.4 Plumbing
3.5 Closed System or Cooling Coil Setup
3.6 Open Bath System Setup
3.7 Startup
Section 4 – Operation
4.1 Selecting the Temperature Unit (°C or °F)
4.2 Displaying and Adjusting the Set Point
4.3 Displaying and Adjusting the Ambient Tracking Offset
4.4 Displaying and Adjusting Remote Control Temperature
4.5 Selecting the Pressure / Flow Rate Display and Units
4.6 Selecting Internal/External Temperature Display
4.7 Setting Operational Parameters
4.8 Display, Alarm, and Error Messages
4.9 Adjusting the High Pressure Bypass Setting
4.10 Enabling/Disabling the Local Lockout
Section 5 – Maintenance and Calibration
5.1 Standard Magnetic Drive Centrifugal Pump
5.2 Condenser, Air Vents, and Reusable Filter
5.3 Fluid Filter
5.4 Fluid Level
5.5 Temperature Calibration
5.6 Flow Rate Calibration
Section 6 - Troubleshooting
6.1 Unit Will Not Operate (No Cooling or Pumping)
6.2 No Pumping
6.3 Insufficient Pumping
6.4 No Cooling or Insufficient Cooling
6.5 Triac Failure
6.6 Internal Probe Failure
6.7 External Temperature Probe Failure
6.8 Diagnostic Mode
Section 7 - Service and Technical Support
7.1 Electrical Wiring Diagram
7.2 Process Flow Diagram
Section 8 - Replacement Parts
Section 9 – RS232
To Next Page
Loading...
Need help?
General
