06
This compressor is powered by an electric motor. This is a dual-voltage
motor, specified 120V or 240V as the customer has requested. Ensure
that it is connected appropriately. The 240V should be wired by an electrician.
Do not operate this compressor on a direct current (DC).
The no load speed of this compressor is approximately 1750 rpm.
This speed is not constant and will decrease under load and/or with
a lower voltage.
A power line intended only for lights cannot properly support a
compressor. Wire that is heavy enough for a short distance is too light
for a greater distance. A line that can support one compressor may not
be able to support multiple devices.
If compressor does not operate when plugged into an outlet, check
the power supply.
Improperly connecting compressor grounding conductor can result
in a risk of electrical shock.
Do not expose compressor to rain or wet conditions. Water entering
compressor will increase the risk of electric shock.
Electrical Connections
Speed and Wiring
SAFETY
INFORMATION
Check with a qualified electrician or service personnel if you are
unsure as to whether the compressor is properly grounded.
Do not modify the plug provided. If it does not fit the outlet, have
a proper outlet installed by a qualified electrician.
Grounding Instructions
This compressor must be grounded. In the event of an electrical short
circuit, grounding reduces risk of electric shock by providing an escape
wire for the electric current. This compressor is equipped with a cord
having a grounding wire with an appropriate grounding plug. The plug
must be plugged into an outlet that is properly installed and grounded
in accordance with all local codes and ordinances.
To Next Page
Loading...