PondMAX EVO II Series

Questions and Answers

A
adamsmaryAug 12, 2025
Why is my PondMAX EVO II not working?
- R
  Robert CunninghamAug 12, 2025
  Your PondMAX Water Pump might not be working due to several reasons. First, ensure the pump is properly connected to a power source and the power point is switched on. Another possible cause is a filter screen blocked with sludge, which requires cleaning. The impeller could also be blocked by sludge or limescale; in this case, clean the impeller following the provided instructions. The impeller chamber might be blocked, or the ceramic shaft could be broken. Clean the impeller and inspect for wear, replacing if necessary. If none of these steps work, submerge the equipment underwater and then plug it in, refilling with water if needed.
K
Kayla HuberAug 19, 2025
What to do if my PondMAX EVO II is noisy?
- W
  Willie WagnerAug 19, 2025
  If your PondMAX Water Pump is making excessive noise, consider the following: * Check for any blockages within the pump and clear them. * Inspect the impeller and shaft for wear; if worn, replace the impeller assembly. * If the impeller is broken, replace it. * Ensure the water level is adequate; if too low, refill to the appropriate height. * Clear any blockages from the unit inlet or water pump outlet. * If the pump is working at its maximum height, select a bigger model.
J
Jessica CastanedaAug 27, 2025
What to do if my PondMAX Water Pump is not working?
- B
  Brendan SpencerAug 27, 2025
  If your PondMAX Water Pump isn't working, first ensure it's properly plugged in and the power point is switched on. Then, check and clean the filter screen or sponge, as well as the impeller, for any sludge or limescale buildup. Make sure the pump is fully submerged in water. Also, inspect the impeller chamber and replace the ceramic shaft if it's broken.
M
martinezwandaSep 3, 2025
Why is my PondMAX Water Pump so noisy?
- K
  Kari Robinson MDSep 3, 2025
  A noisy PondMAX Water Pump could be due to several reasons. Check for blockages in the pump, the unit inlet, or the water pump outlet and clear them. Inspect the impeller and shaft for wear or breakage and replace the impeller assembly if needed. Ensure the water level is adequate. If the pumping height is too high for your model, consider selecting a bigger pump.

PondMAX EVO II Series Specifications

General

Model	EVO II Series
Category	Water Pump
Power Consumption	Varies by model
Voltage	220-240V
Cable Length	10m
Weight	Varies by model
Inlet/Outlet Size	Varies by model