TROUBLESHOOTING
Before troubleshooting, remove power from the chlorinator by turning off at the wall or
removing the mains plug, wait for 10 seconds then re-apply power, this will reset the
internal processor to its default state.
9.
Lights are scrolling 0 - 100%
PROBLEM CAUSE REMEDY
Chlorine output will not
reach 100%
Salt level not high
enough
Salt level should be
4000mg/L
Water temp is low Winter water temps
will reduce output
Cell has too much calcium
deposit on plates
Clean the cell with
cleaning solution or
high pressure hose
Cell could be at end of life If salt level is correct,
water temp is high and
cell is clean you may
require a new cell
No chlorine measured in the
water
Not enough Stabiliser
in the water
Add Stabiliser until you have
30 - 70mg/L
Chlorinator isn’t operating
long enough or at high
enough output
Dirty cell
Increase operating hours or
percentage output
Clean the cell with
cleaning solution or
high pressure hose
Priming cell
No water is flowing through
the cell
Make sure water is flowing
through the cell, pump
may not be operating
Lights are Flashing
Lights will flash when the
chlorinator is turned ON
No action required
Lights are Flashing and
output will only acheive
70%
Auto power reduction due
to High salt condition
5000mg/L or above
Reduce salt level
to 4000mg/L
Lights will flash when you
have a high salt condition
Reduce salt level
to 4000mg/L
Pump is always ON The pump may have been
connected to the mains
before the chlorinator
Make sure the pump is
plugged into the 240V
socket on the chlorinator
Tab on the TIMER has
been set to the wrong
position
See page 7 for instruction
To Next Page
Loading...
