L0311 Rev 3 6-21 © Latham Pool Products, Inc. 2021. All rights reserved. Page 1 of 9
Touch Screen Pool Cover Controller Wiring and
Installation Instructions
Table of Contents
Important Safety Instrucons .................................................................................................................... 1
Installaon Notes ....................................................................................................................................... 1
Product Summary ...................................................................................................................................... 2
Mounng Instrucons ................................................................................................................................ 2
Wiring Descripon ..................................................................................................................................... 3
Standard Setup Procedure ......................................................................................................................... 4
Accessing the Setup Menu .................................................................................................................. 4
Set a Primary Controller ...................................................................................................................... 4
Congure Devices ............................................................................................................................... 4
Verify Connecons and Lock Network ................................................................................................ 5
Assign Main Device ............................................................................................................................. 5
Calibrate each device .......................................................................................................................... 5
Set Passwords ..................................................................................................................................... 5
Edit Service Screen .............................................................................................................................. 5
User Sengs ....................................................................................................................................... 6
Wi-Fi Setup .......................................................................................................................................... 6
Menu Structure .......................................................................................................................................... 7
Mesh Conguraon Opons ........................................................................................................... 9
WARNING! IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
Warning: To avoid re or electrocuon.
Idenfy GFCI breaker at distribuon panel and turn o power before aempng to service or install equipment.
Only install the touch controller to a single gang box rated for outdoor use.
Make motor connecons in an all-weather juncon box as high as possible in the cover box.
Install this device in accordance with naonal and local electrical codes (NEC 680-26).
Electrical wiring and service work should only be performed by a qualied individual.
Warning: To avoid injury or drowning.
The control switch must be mounted in a xed locaon where 100% of the pool surface is visible.
Installation Notes
Use water ght connecons at all wire juncon locaons.
Install device in locaon where exposure to sun and water sources (e.g. sprinklers, water downspouts) are limited.
Make sure all gaskets are undamaged and are clean and free of dirt and debris.
To reverse motor spin direcons, see the “Congure Devices” secon in “Standard Setup Procedure.”
The power circuit should be sized for 15 amps and must be sized accordingly.
Perform a pool calibraon on touch pad aer installaon for accurate current limits and operaonal cycle counts.
Wi-Fi features require a Wi-Fi network to be present and associated to the device to receive alerts.
Keep remote devices in line of sight of controlling devices for best performance.
⚠
To Next Page
Need help?
General
