9
Press and hold this button for more than 5 seconds to view from inside the spa the water
temperature and time display projection, to read these data.
1.5.4. Setting the right time
The controller is fi tted with the RTC system (real-time clock), which works permanently even after
disconnecting the main power. The RTC system makes it easier to use the SPA, since the controller
memorize the clock, fi ltration and the economy mode setting even after the main power is off. It is
not necessary to set the fi ltration start time and its duration again.
To change the RTC system setting:
● Press and hold the clock button for about 5 seconds until the clock icon
starts blinking and
appears permanently on the display.
● Set the hour by using the up/down arrow buttons
● Press the clock button once again to set minutes by using the up/down arrow buttons
● Press the clock button once again to save the current setting after the time modifi cation. If no
button is pressed for longer than 5 seconds, the controller returns to its normal mode without
saving the setting.
1.5.5. Economy mode
After switching on the economy mode (energy saving mode), the controller keeps the temperature
10°C (50°F) lower than that previously set.
When this mode is working, this icon
appears on the display. The economy mode can be activated
(the icon is displayed permanently) or suspended for 40 minutes from the moment of switching off the
last pump, when at least one pump is switched on during this mode. Regardless of the temperature
previously set, the controller maintains the water temperature not lower than 15°C (59°F).
To enter the economy mode:
● Press this button
● The display will then show „Edx”, where x stands for the economy mode duration (from 0 to 24
hours)
Ed0 – the economy mode is switched off,
Ed24 – the economy mode is working continuously.
● To change the hour, use the up/down arrows
and use this button on the control
panel to confi rm the setting.
● After confi rming the settings, the display will show the time when the economy mode is to start.
● Set the hour and minutes using the arrows
and confi rm the setting with this button
● Confi rming the minutes with this button the economy mode is set. The display returns to its
normal status.
The setting of the economy mode is remembered even after the power cut-off.
To Next Page
Loading...
