poolstar SUP STARPUMP-9 - Fault Handling; Maintenance and Storage; Warranty

/14
STARPUMP 9
X. FAULT HANDLING
Fault Inspection Solution
The air
pump
cannot be
started
normally.
1. The power source
is not plugged
properly.
2. Low battery
charge
3. Overheating or
overload causes
motor stop.
1. Make sure that the power wire
is plugged in the 12V DC socket.
2. Charging.
3. Cool the motor and restart it.
4. If the problem cannot be sol-
ved, please contact local service
agents or similar authorized per-
sonnel to change the product.
Slow or
abnormal
ination or
deation.
1. Check whether
the hose is blocked
or cracked.
2. The joint between
the hose and air
pump or air bag
is not installed
properly.
1. Change the hose or make it
unblocked, and check
whether the hose is cracked.
2. Reinstall the hose.
3. If the problem cannot be sol-
ved, please contact
local service agents or similar
authorized personnel
to change the product.
XI. MAINTENANCE AND STORAGE
• After using, or if you want to move, maintain or adjust the product, please
rst pull out the DC plug from the socket.
• when it is idle, it shall be properly stored after being fully cooled.
• It shall not be exposed to the rain or immersed in water.
• Please store it in the dry and ventilated place.
X. WARRANTY
• The warranty period of this product is one year, and it is suggested to use
the original accessories. For any fault not caused by using the original
accessories, it shall be out of the warranty scope.