poolstar SUP STARPUMP-9 - Deflation Process; Precautions and Warnings; Power Source and Usage; Operational Limitations

STARPUMP 9
/7
VIII. DEFLATION OPERATION
• Remove the hose from the ination inlet, Connect the end with exible
conduit adaptor (6) of the hose with the air pump deation outlet (7), and
twist clockwise to tighten it, as Figure 3,and the other end shall still be to
the airbag.
• Press the button of the power switch of air pump, and start the deation
until all the gas is discharged, then the power can be turned o󰀨 to stop
the deation.
IX. PRECAUTIONS
• As this product has a lithium battery, it can work using the battery, or the
plug of the product can be inserted into the cigarette lighter socket on the
car for use.
• The applied power source must be the 12V DC power source (as Figure
8).
• Do not block the ination inlet (1) and Deation outlet (2), and ensure that
the ination inlet (1) and Deation outlet (2) shall remain smooth at all
times.
• Observe the local waste treatment provisions, and it is not allowed to
throw the air pump away randomly.
• Don’t use this product when the hose is damaged, and please change the
hose immediately.
• Don’t pull out the hose when inating, because that the high pressure
may hurt the physical body.
• Don’t make the air pump work for more than 30 minutes, because that
motor overheating may cause internal damage; and the air pump shall be
fully cooled for 30 minutes after continuously working up to 30 minutes.
• Please don’t use this air pump if any part is damaged, and please contact
with the professional personnel to repair it.
• This product shall not be exposed to the rain or immersed in water.
• In order to prevent risk, the ination inlet shall not be forward to face or
body.
• Please don’t not leave while inating.
（Figure 5） （Figure 6）
（Figure 7)
EN