Multi-Purpose Display and Instruments 163
Setting tire sealant/sealing set
f Inflate tires according to the displayed
pressure differences.
A warning appears on the multi-purpose display if
the speed limit of 50 mph (80 km/h) is exceeded.
The reminder SPARE WHEEL/SEALING SET
OPERATION? appears each time the ignition is
switched on.
For information on spare wheel/sealing set opera-
tion: Please observe the chapter “NOTE ON
SPARE WHEEL/SEALING SET OPERATION” on
Page 163.
Warning!
Risk of accident, resulting in serious
personal injury or death if a tire repaired with
tire sealant is in use.
f Avoid hard acceleration and high cornering
speeds.
f Do not exceed maximum speed of 50 mph
(80 km/h).
f Please observe the safety and operating
instructions on the tire compressor.
f Use tires repaired with sealant only over short
distances.
For information on handling and filling the
sealant: Please observe the chapter “TIRE
SEALANT” on Page 334.
Note on spare wheel/sealing set operation
Each time the ignition is switched on,
the reminder SPARE WHEEL/SEALING SET
OPERATION? appears for approx. 10 seconds if a
spare wheel type (spare wheel, collapsible spare
wheel or sealing set) has been set.
1. MAIN MENU
>TYRE PRESS.
>SETTINGS
> TYRES
> SPARE WHEEL
Select and confirm.
2. Select SEALING SET.
3. Confirm selection.
The display automatically returns to
the TYRE PRESSURE sub-menu
(filling information).
1. Select YES or NO:
- YES if a spare wheel, collapsible
spare wheel or tire sealant is still
being used.
- NO if the spare wheel, collapsible
spare wheel or tire sealant has
been removed.
2. Confirm selection.
The selected item is then accepted.
The current settings are displayed if
NO is selected.
To Next Page
Loading...
Need help?
General
