EasyManuals Logo

Porsche 2007 Cayenne User Manual

Porsche 2007 Cayenne
428 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #275 background imageLoading...
Page #275 background image
Parking 275
Assigning garage door opener signal to
key with fixed code system
1. Please follow the operating instructions for the
original hand-held transmitter.
2. The standard codes set at the factory must be
deleted before programming for the first time.
3. Point the original transmitter at the marked
position.
4. Press the button of the original hand-held trans-
mitter and the button to be allocated on the
keypad simultaneously (see illustration).
5. Keep both buttons depressed until light-
emitting diode B starts to flash (first slowly and
then quickly).
Only release both buttons when light-emitting
diode B flashes quickly.
The rapidly flashing light-emitting diode B
confirms that the new signal has been
programmed successfully.
6. Repeat steps 1 to 3 to assign signals to the
other buttons.
Assigning garage door opener signal to
key with changeable code system
1. Please follow the operating instructions for the
original hand-held transmitter.
2. The standard codes set at the factory must be
deleted before programming for the first time.
3. Point the original transmitter at the marked
position.
4. Press the button of the original hand-held trans-
mitter and the button to be allocated on the
keypad simultaneously.
5. Keep both buttons depressed until light-
emitting diode B starts to flash (first slowly and
then quickly).
Only release both buttons when light-emitting
diode B flashes quickly.
The rapidly flashing light-emitting diode B
confirms that the new signal has been
programmed successfully.
6. To synchronise the system:
Press the programming button on the receiver
for the garage door drive.
Afterwards, you usually have approx.
30 seconds to initiate step 5.
7. Press the button to be assigned on the keypad
twice (for some devices you must press the
key on the keypad a third time to complete the
setting process).
8. Repeat steps 1 to 5 to assign signals to the
other buttons.
Note
f Please consult your authorized Porsche dealer
if you have not been able to successfully
assign signals to the buttons even though you
have carefully followed the instructions in this
chapter and the operating instructions for the
original hand-held transmitter. Your authorized
Porsche dealer has a list of all garage door
opener signals that can be taught.
Operating the garage door opener
f Press the corresponding button on keypad A.
Light-emitting diode B lights up during signal
transfer.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Porsche 2007 Cayenne and is the answer not in the manual?

Porsche 2007 Cayenne Specifications

General IconGeneral
BrandPorsche
Model2007 Cayenne
CategoryAutomobile
LanguageEnglish

Related product manuals