Air Conditioning, Parking Heater and Heated Rear Window 95
f Press button .
The air flows to the footwell.
Ending air distribution functions
f Press the relevant button again or
f Press the AUTO button C.
Accepting settings for driver’s side for the
entire vehicle
The MONO function allows the temperature and air
quantity settings for the driver’s side to be
accepted for the entire vehicle.
Switching on MONO function
f Press button in the front control panel
for 2 seconds.
The MONO logo appears on the air-conditio-
ning display panel.
Ending MONO function
f Press button in the front control panel
for 2 seconds or
f Change the settings in the air-conditioned
areas.
f Press button on the front control panel.
Indicator light lights up.
The air flows to the windshield and the front
side windows.
The windshield is demisted or defrosted as
quickly as possible.
Ending the function
f Press button again or
f Press the button .
f Press button on the front control panel
once.
Indicator light in button lights up.
Control of the outside-air supply depends on
the air quality.
Note
The recommended operating mode is automatic
recirculating-air mode.
Air to footwell Defrosting the windshield
Switching automatic recirculating-
air mode on
Warning!
Risk of accident due to impaired vision,
resulting in serious personal injury or death.
In recirculating-air mode, the windows may
mist up.
f Only select recirculating-air mode for short
periods.
f If windows mist up, end recirculating-air mode
by pressing the recirculating-air button again
and selecting the function “Defrost wind-
shield”.
f Press button on the front control panel
twice.
Indicator light in button lights up.
The outside-air supply is interrupted and only
the inside air is circulated.
Note on operation
When the air-conditioning compressor is switched
off manually or automatically, recirculating-air
mode ends after approx. 3 minutes.
Switching recirculating-air mode
on
To Next Page
Loading...
Need help?
General
