INSTALLATION GUIDE
MOUNT THE OPERATOR(S)
3
4
Key slot configuration & location screw mounted in backplate.
WWW.PORTALP.COM | 15
Automatic Doors & Building Access Control
SW10 (Full Power) & SW19 (Low Energy)
For pull application the motor should be located near the hinge side of the door.
For push application the I/O board should be located near the hinge side of the door.
Re-align locating screw to key slot, insert drive plate and shift to the right into position.
Re-position the four (4) screws to secure the drive plate.
To Next Page
Loading...