INSTALLATION GUIDE
SET THE DIP SWITCHES ON THE I/O BOARD
§ Set the dip switches according to the application.
§ Dip switches are used to apply specific functions to the control.
§ There are 3 sets of dip switches. TWO 2 - POSITION on the I/O board (DS1 & DS2), and a 10-position
at the adjustment board (SW2).
DS2 DS1 NOT USED
WWW.PORTALP.COM | 25
Automatic Doors & Building Access Control
SW10 (Full Power) & SW19 (Low Energy)
To Next Page
Loading...