INSTALLATION GUIDE
PUSH ARM INSTALLATION
All push arms come standard with 35mm spindle. 50mm and 80mm available as an accessory.
Attach the primary door arm approx. 20 degrees past perpendicular and towards the closing direction as shown.
If more spring tension is desired, simply increase the mounting angle to greater than 20 degrees so it results in
increased preload.
(BOX CONTENT - Page 33 - 35)
(BOX CONTENT - Page 33 - 35)
WWW.PORTALP.COM | 18
Automatic Doors & Building Access Control
SW10 (Full Power) & SW19 (Low Energy)
(INCLUDED WITH DOUBLE EGRESS ARM)
(INCLUDED WITH PUSH ARM)
(INCLUDED WITH DOUBLE EGRESS ARM)
To Next Page
Loading...