INSTALLATION GUIDE
120 VOLT AC ELECTRICAL CONNECTION
Connect the main power to the Black / White / Green connector on the back-plate.
§ Main power supply: 120 VAC, 15A, Single Phase, 60 Hz. circuit
§ Attach the incoming 120 volt AC line wires to the wiring provided in the header – as shown below.
DO NOT TURN POWER ON until all remaining wiring has been completed.
BLACK: 115 VAC Power
WHITE: Neutral
GREEN: Ground
WARNING: Ensure all incoming electrical power is shut off
before proceeding with any wiring to SW10/19. Use only
with wire harness provided; failure to do so may result in
damage to equipment or personal harm as well as voiding
the warranty.
AVERTISSEMENT: assurez-vous que toute alimentation
électrique entrante est coupée avant de procéder au
câblage du SW10/19. À utiliser uniquement avec le faisceau
de câbles fourni; le non-respect de cette consigne peut
entraîner des dommages matériels ou corporels ainsi que
l'annulation de la garantie.
WWW.PORTALP.COM | 22
Automatic Doors & Building Access Control
SW10 (Full Power) & SW19 (Low Energy)
To Next Page
Loading...