Need help?Do you have a question about the Portalp SW10 and is the answer not in the manual?
General| Brand | Portalp |
|---|---|
| Model | SW10 |
| Category | Door Opening System |
| Language | English |
Notes specific sensor requirements for low energy operation.
Detailed dimensions for preparing the door frame for push side mounting.
Detailed dimensions for preparing the door frame for pull side mounting.
Dimensions for preparing the door frame for double egress configurations.
Explains how to orient the operator for push applications relative to the hinge jamb.
Explains how to orient the operator for pull applications relative to the hinge jamb.
Identifies push arm components and outlines adjustment procedures and dimensions.
Provides important notes and clarifications regarding operator power status and indicator LEDs.
Emphasizes the need for re-learning if the operator stroke is altered.
Details the function of each dip switch on the adjustment board for various settings.
Lists terminal positions, functions, and descriptions for the I/O board.
Details wiring for specific terminal strips on the I/O board.
Outlines the steps for adjusting mechanical doorstops and setting the hold open position.
Lists components for single operator with push arm (Clear Anodized).
Lists components for push arm (Clear Anodized).
Lists components for single operator with pull arm (Clear Anodized).
Lists components for pull arm (Clear Anodized).
Lists components for double header operator (Clear Anodized).
Lists components for double header operator (Dark Bronze).
Wiring diagram for low energy setup with push plates and door-mounted sensor.
Wiring diagram for connecting two operators to work simultaneously.
Diagram showing wiring for wireless activation and electric strike.
To Next Page